PROBE TESTINGTest probesPassive probe tips

PTG20Tungsten probe tip

General purpose probe tip sharpened at one extremity, the body material (tungsten) is strong enough to be bent into a variety of shapes.

- The standard application is probing on pads and/or internal lines
- Material tungsten, length 38 mm, tip radius from 0.5µm to 100µm
- Nickel-plated option is available for body only (easy soldering), please add the suffix ''N'' to the P/N

PTG4Copper probe tip with tungsten wire

The wire-tip combines a rigid body with a thin tungsten wire of various diameters, the probe tip is then soft enough to avoid damaging the probing pad materials.

- Length of body 51 mm, tungsten wire 3 to 5 mm
- Body diameter 0.51 mm, wire 5 to 125 microns
- Tip radius 0.1 to 5 microns
- Most popular references : PTG410, PTG422, PTG435, PTG4135
- Download the full list below for more information

PTSE-TGGold plated tungsten probe tip

Gold plated tungsten straight probe tip, the rigid body can be bent and/or cut to clear space above for very short working distance objectives.

- The standard application is probing on pads and/or internal lines
- Tip material provide a good answer to probing on soft surface

PTSE-TCTungsten carbide probe tip

Tungsten carbide straight probe tip, the rigid body can be bent and/or cut to clear space above for very short working distance objectives.

- The standard application is probing on pads and/or internal lines
- Tip material provides a good answer to probing on hard surface and for continuous probing

PTSE-OOsmium probe tip

Osmium straight probe tip, the rigid body can be bent and/or cut to clear space above for very short working distance objectives.

- The standard application is probing on pads and/or internal lines
- The Osmium material is particularly suited for soft surface needing a good contact

PTSE-PPalladium probe tip

Palladium straight probe tip, the rigid body can be bent and/or cut to clear space above for very short working distance objectives.

- The standard application is probing on pads and/or internal lines
- The palladium material is particularly suitable for surfaces that are difficult to contact or for low current measurements

PTSE-20BCBeryllium copper probe tip

beryllium copper straight probe tip, the rigid body can be bent and/or cut to clear space above for very short working distance objectives.

- The standard application is probing on pads and/or internal lines
- Tip material provides a good answer to probing at high current or on soft surface

MWPA-10High-Speed passive multipurpose probe

Multipurpose passive high-speed probe, used for driving and receiving signals, frequency response from DC to 11 GHz (500 ohm input impedance mode).

- Adaptable on any micropositioner, specify type
- Coaxial 50 ohm cable included (1 m long), terminated by SMA and miniature connector to the coaxial probes
- Easily replaceable coaxial probe tips of 1.5 inch long, 1 or 2 probe points
- Tailored to different input impedance, 50, 250, 500 or 5k ohm by input resistance added

ABOUT OUR Passive probe tips

Standard range of probe tips for all pad size including very small or internal lines, lenght 19 to 50 mm, diameter 0.51 or 0.6 mm
• Two series : All Tungsten body or small-tungten-wire (flexible)
• Tip radius down to 1/10 of micron
• Special models are available for non-standard materials, difficult to contact or very-specific-nature...
• The probe tips are mounted on the standard or coaxial probe holders